Search
Search
Confirm
Cancel
CONTACT
/
/
/
Smart shooting gimbal factory shares common gimbal failures

Smart shooting gimbal factory shares common gimbal failures

 一. The smart shooting gimbal factory found that the code switch light does not flash

customized smart shooting gimbal

  Smart shooting PTZ software settings

  1. Decoder settings in the software, 2. Replace 1 COM port, 3. The hardware, after the above settings, still cannot be used normally, open the 9-pin to 25-pin converter interface.

  二. Unable to control the decoder

  There is no relay sound in the decoder.

  1. The smart shooting gimbal factory recommends to check whether the decoder is powered; 2. Check whether the code converter is pulled to output 485 signal; 3. Check whether the decoder protocol is set correctly; 3. 4. The smart shooting gimbal factory recommends to check whether the baud rate setting is in line with the decoder; 5. 5. Check whether the connection between the decoder and the code converter is wrong; 7. The smart shooting gimbal factory recommends to check whether the decoder works normally, if so, the decoder works normally, otherwise the decoder is faulty; 7. Check if the fuse of the decoder is burned out.

  三. Unable to control the gimbal

  1. The smart shooting gimbal factory checks whether the sixth item above is normal 2. Whether the voltage of the 24V or 220V power supply port of the decoder is output normally 3. Directly supply power to the UP, DOWN, and PTCOM lines of the gimbal, and check whether the gimbal can work normally 4. The smart shooting gimbal factory checks whether the power supply interface is connected incorrectly 5. Check whether the circuit is connected incorrectly.

ENTER YOUR EMAIL TO STAY IN TOUCH

Username used for comment:
邮件订阅
Description:

邮件订阅

CONTACT US

这是描述信息

© 2021 Topjoy International development Group Co., Ltd., All rights reserved.  粤ICP备15077352号    Powered by 300.cn