Search
Search
Confirm
Cancel
CONTACT
/
/
/
China soap dispenser troubleshooting knowledge

China soap dispenser troubleshooting knowledge

  If the soap dispenser has been idle for a period of time, some soap may condense in the soap dispenser. If the amount of soap is small, it can be stirred with warm water. This will restore the soap to liquid. If the above method is not feasible, put the condensed soap Remove the liquid, add warm water, and use the soap dispenser several times until the warm water runs out of the China soap dispenser, which will clean the entire China soap dispenser. Please note that dust and impurities in the soap will block the liquid outlet. If you notice that the soap in the inner bottle has deteriorated, please replace the soap.

soap dispenser

  If the soap liquid is too thick, the China soap dispenser may be out of liquid, in order to dilute the soap liquid, you can add a little water and stir it before use. When using the China soap dispenser for the first time, add clean water to discharge the vacuum inside. When adding soap, the inner bottle and pump head may contain some clean water when using the product for the first time. This is not a quality problem of the product. It is left over from the inspection before the product leaves the factory.

  With the improvement of the technology of soap dispensers in China, the reasonable capacity design of soap dispensers on the market can make the soap liquid reasonably use up within the shelf life. Avoid the occurrence of bad appeals.

ENTER YOUR EMAIL TO STAY IN TOUCH

Username used for comment:
邮件订阅
Description:

邮件订阅

CONTACT US

这是描述信息

© 2021 Topjoy International development Group Co., Ltd., All rights reserved.  粤ICP备15077352号    Powered by 300.cn